Effective cleaning and paint removal with up to 3,000 bar high-pressure water.
Treatment with water at high pressure enables high area performance in a short time and lets surfaces look like new. The substrate is optimally prepared at the same time. Completely without chemicals. Completely without blasting material. Surface cleaning and renovation in one step and with minimum disposal costs. Conventional sand blasting methods for cleaning ship hulls are very contaminant-laden and environmentally harmful. For environmental reasons and due to the high disposal costs of contaminated blasting material, sand blasting is being increasing replaced worldwide by ultrahigh-pressure jet technology.
High-pressure water jetting produces only very low impact forces. Layers are removed selectively, without attacking the base material. Damage to structures is also eliminated, just as are blasting material residues. In contrast to this, sandblasting leaves residues on the treated surface that are not visible to the naked eye, which gives rise to faulty coating.
Neither gases nor slags are produced No chemical or abrasive additives are used in the application, which means that the quantity of material to be disposed of is reduced to a minimum. The result is convincing in all cases: high cleaning quality, high effectiveness even in difficult to reach areas, high cleaning quality and a high degree of protection for user and environment.
Fast and effective removal of algae and shells
WOMA high-pressure waterjetting technologies can do much more than just cleaning ships.
What high-pressure jetting can do for ships applies also to buoys, cans and beacons, in docks, on barrages and ship lifts. As with ships, the fast and effective removal of algae, barnacles and other problematical deposits is a core task in the value retention and maintenance of navigation aids and construction plants.
The mobile, compact and flexible-use high-pressure systems from WOMA are available for the highly varied application areas. These systems achieve high cleaning and surface performances. If required, surfaces can roughened and damaged locations exposed in the same working operation.
TURBO NOZZLE COMPACT TD-C: ERGONOMIC – LIGHT – COMPACT
The TD-C is used for industrial cleaning, surface treatment and removal tasks and is designed for a pressure from 500 bar to 3,000 bar and a maximum nominal flow rate of max. 45 l/min.
The TD-C is a lightweight and compact alternative to the existing TD-3000 SCS series. In direct comparison, the dimensions and weight have been reduced. The nozzle can therefore also be used in confined cleaning environments and impresses with its low vibration emissions.
Advantages at a glance:
■ Optimised with substantially reduced dimensions
■ 3-stage speed setting via intuitive slider control
■ Speed regulation via magnetic field-oriented induction brake, wear-free and without friction loss
■ Nozzle carrier head with hydraulic self-drive through adjusted nozzle openings
■ Easy maintenance and short set-up times – no special tools required.
Application and areas of use:
■ From 500 bar cleaning of surfaces, e.g. graffiti removal
■ From 1,000 bar treatment of surfaces, e.g. roughening
■ From 2,500 bar removal of surfaces, e.g. concrete removal
Đánh giá
Chưa có đánh giá nào.